Conveyor Dust Control: Dust Fogger Systems
A simple and very effective solution to the serious
problem of airborne dust.
Our Dust Foggers use water only -- no air or chemical
injectors are required. The Fogger's nozzles generate a
finely atomized fog with a very uniform distribution. The
fog clings to dust particles, making them too heavy to
float. For a cost effective means of dust control, the Dust
Fogger System is the way to go.
- Very low water consumption
with average consumption of less than 5.7 gph per
nozzle. Lower water usage means less moisture added to
the conveyed material.
- Modular design allows
the system to adapt if your conveyor conditions change.
- Minimizes operating cost
because no soaps, detergents, surfactants, air pressure,
or expensive high pressure pumps are required.
- Manufactured of corrosion
resistant materials.
- Low maintenance and easy to
install. Lightweight and compact.
- Operating pressure of 100-150
psi.
- Turn-key systems available.
 
Simplicity Chute Baffle
Eliminates fugitive dust at transfer points using a
three-stage curtain with a nylon bristle strip to trap dust.
Dust from load chutes and head box inlets are a major portion
of dust emissions, causing bad housekeeping and even citations
from air quality regulators.
The Simplicity Chute Baffle prevents fugitive dust
emissions with a three-stage curtain incorporated into the
baffle. The outer layers are wear-resistant urethane strip
curtains. Sandwiched between the two is a nylon bristle strip,
which acts as filler and prevents dust from escaping between
the slits in the urethane curtain. Combined with an Arch Dust
Fogger system, the Simplicity Chute Baffle will virtually
eliminate dust when installed properly at your transfer
points.
          |
